There was a problem loading the comments.

Partial neck sizing with collet die

Support Portal  »  Knowledgebase  »  Viewing Article

  Print
If you want to resize just a part of the neck, find a washer at your local hardware store the has an inner diameter large enough to fit over the case, and an outer diameter large enough so that it contacts the sleeve that protrudes from the bottom of the die. Slide this washer over the case after the case has been inserted into the shell holder. Now when the Ram is raised, you can still close the collet by applying force at the bottom of the lever stroke, but the case will not go up as far into the collet, and the neck will be sized less an amount equal to the thickness of the washer.

Share via

Related Articles


Self-Hosted Help Desk Software by SupportPal
© Lee Precision, Inc.