There was a problem loading the comments.

Reconnecting the Case Feeder Spring

Support Portal  »  Knowledgebase  »  Viewing Article

  Print
The Case Feed Spring attaches to a black bushing with a hook called the Spring Attach, and is located on the front Column of the Auto Breech Lock Pro. If the Spring should come off of this hook, slide the Slider Block forward on the rail, as if you are inserting a case, and reattach the Spring. If you are unable to reattach the Spring in this manner, you may need to remove the Tool Head.
Using the Allen Wrench included with the press, unscrew and remove the Allen Head screws from the Tool Head and lift the Tool Head off the press. This will allow access to the Spring Attach and can reattach the Spring to the hook at this point. Replace the Tool Head and screw the Allen Head Screws back into place when you are complete.

Share via

Related Articles


Self-Hosted Help Desk Software by SupportPal
© Lee Precision, Inc.