View a help video on how to remove a stuck case
- Heavy hammer
- 3/16" drift punch
- 3/4" wrench
- 1/2" wrench
1) Leave the die in the press for this operation. Loosen, but do not remove the decapper clamp with a 3/4" wrench on the wrench flats on the die body, and a 1/2" wrench on the decapper clamp.
2) Pound on the end of the 3/16" drift punch with a heavy hammer to release the stuck case.
Replacement sizing dies may be purchased at a 50% product discount by applying the coupon code below to your shopping cart:
Rifle sizing dies =
LEELUBEWORKSCarbide sizing dies =
CARBHALFOFFTo keep this problem from happening again, use Lee Resizing Lubricant. It works where others stick to cases. Using some Lee Resizing Lubricant, spread a small amount around the case below the shoulder so that there is a thin film. With the small amount of film that remains on your finger, scrape some into the inside of the case neck.
