If you wish to change or adjust your bullet seating screw for any reason, below are the steps to remove or adjust screw.
Removing existing screw:
- Remove ¼-20 acorn nut
- Screw thimble into the die until the thimble separates from screw.
- Remove screw.
Installing new screw:
- Turn new screw in a couple turns.
- Push thimble on to screw and rotate until bottom of thimble is aligned with a horizontal line (.1, .2, .3, etc.).
- Remove thimble, and re-install with "0" aligned with the vertical line. Push thimble on without turning the screw.
- Tighten ¼-20 acorn nut while holding thimble.
