Primer Catcher for Pro 1000 red base

If you have a Pro 1000 with red aluminum base, you can add your own primer catcher.

Parts needed are as follows:
1 double 1in. female connector.
1 45 degree double female connector
1 female connector with a threaded end.
1 adapter with a 1in. female threaded end and a 2in.male connector.
1 double female connector.
1 2in. cap.
Approximately 5 inches of 1 inch pvc and 4 inches of 2 inch pvc.
First outline the position of the press. Then using a 1 inch hole cutter at a 45 degree angle. Then tapping the 1 inch female connector into the hole. Using a hack saw blade. Cut it level to your bench. The all that is left is attach the remaining pieces as shown in the pictures. This set up will catch a 1000 plus primers.