Pro 1000 Case Sensor Assembly

The correct order for the assembly of the primer feed on the Pro 1000 is as follows: first drop in the primer pin, with the long end facing up, place the primer spring over the pin. Then press the primer trough into the recess in the shell plate carrier.

The case sensor is assembled as follows: first place the tension finger on the shell plate carrier casting, with the hooked end around the small pin cast as part of the carrier casting. Then slide the small end of the case sensor bushing into the hole in the case sensor, and insert the case sensor screw through the small end of the cse sensor bushing. Place this assembly on the top of the tension finger so the screw threads into the hole in the shell plate carrier casting. Do not overtighten the case sensor screw, the case sensor must be free to pivot on the case sensor bushing.