If you believe that the threads in the die are damaged, you are able to retap the die. It is a tapered threaded hole in the top of the die. The tap size is 1/8-27 NPT. You need to be very careful starting the tap so you do not damage the threads in the die. Be sure to run the tap deep enough to completely clean the top threads or the new Clamp will strip on the way in. If the threads are beyond repairing on your own with a tap, you will need to send the die into us for repair/replacement.
If a new Clamp is needed, there are two options to obtain a replacement part.
The replacement part is available from our website at a 33% discount, you can place your order for the part through this link: https://leeprecision.com/decapper-clamp
-or-
Mail the part in to the factory at the address below for a no charge replacement.
