Lee Bullet Feed Kit

Lee Bullet Feed Kits were produced for progressive presses 1992 to 2023. They were discontinued in 2024 due to customer demand for our Inline Bullet Feed Kit System.

The Bullet Feed Kit was designed to directly fit the Pro 1000. Automatically feeds bullets into the mouth of the bullet seating die. Align bullets more accurately than possible by hand and increases the cyclic rate 50 to 100%. The Bullet Feed Kit is complete for one bullet diameter and range of length. To determine which Bullet Feeder you need, you will need to measure the bullet's diameter and, most importantly, the length of the bullet in inches. To convert to another caliber or bullet length select appropriate Feed Die & Finger and purchase corresponding Lee bullet seat and feed die.

Note for Pro 1000's built prior to 1992:  these presses do not have the attach lug necessary to mount the Bullet Feed Kit to the carrier. If you have an older carrier, this kit will not work on your press.

Note for Pro 4000 | Auto Breech Lock Pro owners:   presses require 1 steel breech lock bushing and 1 lock ring to mount to Bullet Feed Kit (items sold separately).

The tube holds 25 bullets. The kit comes with 2 tubes (small and large), when you load small bullets, the small tube fits inside the large tube. When you load large bullets, the small tube is removed.

The Multi-Tube Feeder accessory for the bullet feed kit will allow you to hold approximately 100 bullets.

Please note, the bullets that work the best in the bullet feeder are jacketed or lead round nose flat base bullets.

The Bullet Feed Kit was available in the following bullet diameter's and length's.