LoadMaster Load-Master caliber or cartridge switch

To convert the Load-Master from a large caliber to small caliber or a small to large, you may need the following:

1) New Shell Plate
Appropriate shell plate = https://leeprecision.com/load-master-shell-plates

2) Primer Feeder
If you are loading a larger or smaller primer, a new primer feeder needs to be purchased.
Large (90077) 
Small (90075)

3) Dies

Appropriate dies = https://leeprecision.com/reloading-dies

4) 5 Hole Turret (90079) = https://leeprecision.com/5-hole-turret

5) Powder Measure

• If you are going to load rifle cases with the Pro Auto Disk Powder Measure, you will need a Short Charging Die (90668) or Long Charging Die (90194) = http://leeprecision.com/rifle-charging-die.html and for some loads, it will require the Double Disk Kit (90195) = https://leeprecision.com/double-disk-kit
• For larger rifle cases, greater than 3.10cc capacity, you will need the Auto-Drum powder measure (90811), and the short charging die (90668) for cases .860 to 1.760" inches long, and the long charging die (90194) for cases 1.760" to 2.620" long.

6) Bullet Feed Kit
If you are loading a larger or small diameter cartridge, a new Bullet Feeder and Lee Bullet Seat and Feed Die may also need to be purchased = http://leeprecision.com/reloading-presses/progressive-presses/progressive-press-accessories/bullet-feed-kit/

NOTES: Some 45 ACP brass now have small primer pockets. Do not attempt to load these cases with large primer feed, else explosion and damage to tool is likely to occur.
If the desire is to load the 40 S&W, it is necessary to have the Universal case feeder.

The 50 AE can be loaded however, the case feeder cannot be used as event the large size is too small. It is also necessary to lube the cases as the dies are steel.

Rifle Load-Master Setup

Pistol Load-Master Setup

Universal