There was a problem loading the comments.

Load Master Priming Pin Leaving Crescent Impression

Support Portal  »  Knowledgebase  »  Viewing Article

  Print
You may be trying to seat the primer too deep. If it can’t push the primer any deeper, it will create an impression in the primer. Back the pin off one wrench flat at a time.

If you have the small priming pin installed in the large primer feeder. Install the correct priming pin.

If there is a large radius on the edge of the priming pin it may create an impression in the primer. Replace the pin.

Share via

Related Articles


Self-Hosted Help Desk Software by SupportPal

Categories

Tags

© Lee Precision, Inc.